The Group has diversified into Spinning during 2005 and M/s Amoda Spintex Limited was stated for the manufacture and exports all types of yarns. Polyester, Cotton, Combed and Textile yarns are the products of Amoda Spintex Limited. The Group is delighted to announce that Amoda Spintex has a very modern sophisticated and fully automated Spinning facility located at Jaggiahpet, Andhra Pradesh and is one of the largest cotton yarn producers of the country.



To get a uniform end product consistently from highly variable characteristics of input fibres, mixing of different lots is done. Grading or segregation takes place before mixing to remove unwanted contamination in cotton.


Blow room consists of a sequence of different machines that carry out Opening, Cleaning, thorough Mixing and decreasing the tuft size smaller and smaller, to feed material to Carding uniformly and continuously.


"Card is the heart of the spinning mill" and "Well carded is half spun" are two proverbs of the experts. The purpose of Carding is to open tufts to individual fibres, neps reduction, and elimination of dust and orientation of fibres into sliver form.


The object of draw frame is to double and draft the slivers and thereby make even sliver and parallelization of fibres i.e. hooks created at Carding are removed.


The object of Lap Former is preparation of Lap from slivers with optimum parallelized fibres and feeding of trailing hooks from Carding as leading hooks at Comber to reduce long fibre loss in the noil.


Combing is the process which is used to upgrade the raw material and to produce an improvement in yarn quality by elimination of short fibres, elimination of remaining impurities and elimination of neps.


The object of Fr. Draw frame is to double and draft the slivers and thereby make even sliver, parallelization of fibres and auto levelling of linear density variations in feeding to get constant linear density of output sliver.


The object of Simplex is to produce roving suitable to feed Ring frame by means of attenuation - drafting of sliver, twisting the drafted strand and winding the twisted roving on a bobbin.


Functions of Ring frame are to draft the roving until the required fineness is achieved, to impart strength to the fibre, by inserting twist and to wind up the twisted strand (yarn) in a form suitable for storage, transportation and further processing.


The object of Auto corner is to eliminate the faults and contamination in yarn and joining the ends with splice and winding of long and continuous yarn into conical shape to facilitate at further processes.


The object of packing is to check visual defects through UV lamps and pack the material suitable for storage and transportation with necessary labels.




The apposite spot for your systematization needs